No PFAS detected

PFAS in Dayton, TX drinking water

2 public water systems serving ZIP codes in and around Dayton were tested by EPA for 29 PFAS and lithium. No PFAS were detected.

ZIP codes

77535

Water systems

City of Dayton

Serves about 15,393 people · Groundwater · Sampled 2023-06 to 2023-12 · 4 samples at 2 locations · PWS ID TX1460002

No PFAS detected

ChemicalAverage*HighestLevelStatus
lithiumLithium16avg16.5max10 µg/LEPA health reference levelAbove screening level4 of 4 samples

29 of 29 PFAS tested were not detected. *Highest sampling-location average (non-detects counted as 0), the way EPA compares UCMR 5 data to the PFAS limits. PFAS in parts per trillion (ppt = ng/L); lithium in µg/L.

Health-based violations since 2016 (0)

No health-based violations recorded in EPA SDWIS since 2016.

Full report for City of Dayton →

City of Mont Belvieu

Serves about 12,864 people · Groundwater · Sampled 2025-04 to 2025-12 · 7 samples at 3 locations · PWS ID TX0360017

No PFAS detected

ChemicalAverage*HighestLevelStatus
lithiumLithium25.1avg26.7max10 µg/LEPA health reference levelAbove screening level6 of 6 samples

29 of 29 PFAS tested were not detected. *Highest sampling-location average (non-detects counted as 0), the way EPA compares UCMR 5 data to the PFAS limits. PFAS in parts per trillion (ppt = ng/L); lithium in µg/L.

Health-based violations since 2016 (5)
  • 2026-01-01 TTHM Stage 2 Disinfectants and Disinfection Byproducts Rule · measured .084 MG/L Resolved
  • 2025-10-01 TTHM Stage 2 Disinfectants and Disinfection Byproducts Rule · measured .082 MG/L Resolved
  • 2024-10-01 TTHM Stage 2 Disinfectants and Disinfection Byproducts Rule · measured .081 MG/L Resolved
  • 2022-10-01 TTHM Stage 2 Disinfectants and Disinfection Byproducts Rule · measured .081 MG/L Resolved
  • 2022-04-01 TTHM Stage 2 Disinfectants and Disinfection Byproducts Rule · measured .082 MG/L Resolved
Full report for City of Mont Belvieu →

Filters certified for what was found

Here, lithium averaged above EPA's screening level.

Certification tests use PFOA/PFOS levels far above tap water and do not yet show reduction down to 4 ppt. Replace cartridges on schedule. Check the model number on the certifier's site (IAPMO, NSF, WQA). As an Amazon Associate we earn from qualifying purchases. How we pick filters

Questions

Is Dayton tap water safe to drink?

EPA's tests found no PFAS at reporting levels in the water serving Dayton. EPA SDWIS lists 5 health-based violations since 2016 for these systems; see each system below. This is monitoring data, not a safety ruling. Your utility's annual Consumer Confidence Report has the full picture.

Are there PFAS in Dayton water?

No PFAS were detected at EPA's reporting levels in the 2 water systems tested in and around Dayton. Results by system are listed above.

Who supplies drinking water in Dayton, TX?

The largest tested public water systems serving ZIP codes in and around Dayton are City of Dayton (about 15,393 people), City of Mont Belvieu (about 12,864 people). Your address may get water from only one of them; it is named on your water bill.

What filter removes PFAS from Dayton tap water?

Pick one whose NSF/ANSI 53 or 58 certification names PFOA and PFOS, from NSF, IAPMO R&T, WQA, CSA or UL. Certified pitchers start around $35; under-sink carbon and reverse osmosis systems cost $150 to $700. Reverse osmosis also handles shorter-chain PFAS better. See best water filters for PFAS.

How can I test my own tap water for PFAS?

Lab mail-in kits cost about $85 to $335 or more. See how to test water for PFAS.

More for Dayton, TX